GM Volt Forum banner

So, I got the dreaded "Service High Voltage Charging System".

5564 Views 10 Replies 7 Participants Last post by  indyflick
....but I'm not that worried about it as I know (having learned about it here) that it's almost certainly just the typical coolant tank sensor issue. I checked the battery coolant level and it's right where it's supposed to be with zero sign of any leakage anywhere. FWIW as well the car has had all the updates done, anti-tamper guard on the coolant tank, etc.

The car is still under the Voltec warranty so I have an appointment to take it to the dealer Wednesday.

Two questions - I hooked up my scantool and here's the codes I got:

Are these typical of the codes one would expect for the sensor issue?

And secondly, I had always been under the impression that the SHVCS code/error was only clearable by a dealer (?), but since it was stopping us from charging I commanded my scantool to clear the codes and boom, check engine light went off and the car honked, dash light turned green, and it started charging immediately. It tossed the code again the next day (Saturday) but again I reset it (with the same success) and it's been fine since, hence why I'm sure this is just an intermittent sensor thing.

Is this actually normal for those of us with our own scantools to be able to reset this, and all the stories about "requiring an expensive visit to the dealer to have it reset" is just specific to those without their own scantool?
See less See more
1 - 1 of 11 Posts
Re-read my post. I cleared them. The car is charging again just fine. P1FFD remains listed as a "permanent" code (Hybrid/EV Battery Pack Coolant Level Sensor Circuit High Voltage) but aside from that the car is operating normally, including charging.
No problem. Just reset it every day with your tool, haha. For what, $30? you could have avoided all of this, the daily resets, the dealer visit.
1 - 1 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.