[Steverino]

can someone point me in the right direction as far as removing the rubber strips

1. Begin at the rear edge of the roof panel joint finish moulding and carefully pry the moulding from the roof ditch clip.
2. Pull the moulding forward out of the ditch.
3. Carefully lift the front edge from the second roof ditch clip.
4. Clean any adhesive residue from the ditch using a 50 / 50 mixture by volume of isopropyl alcohol and clean drinkable water.
5. Dry the ditch with a lint free cotton towel.



Antenna:
1.Lower the rear of the headlining trim panel
2. Remove Radio Antenna Base Fastener (use a new on to re-install)
3. Remove Electrical Connectors

 

[Steverino]

This thread is about removing the exterior roof trim, antenna, not dipping. Please start a new thread on dipping or wrapping if that is your focus.