GM Volt Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Hi!

I have my 2x12" laying around and I would like to install these in my Ampera 2013. In my past car, Audi TT mk2, it had RCA because it had an aftermarket stereo so that installation was no problem for me. This car does not have RCA.
I do Not have Bose.

How do I wire my SoundDigital 1200.1d AMP Input?

This is how the amp looks like: ( Amazon.com: SounDigital 1200.1D EVO 1200W Monoblock Car Audio Amplifier: Car Electronics )

Any help would be much appreciated!
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #3 ·

·
Registered
Joined
·
320 Posts
Thank you so much! But I see a problem, the amplifier only has 1 RCA for Input. The other one on the amp is for output. Will this work anyway or do I need a different converter?
It'll still work anyway. You'll be getting your bass signal from one side, but there's no difference in left/right bass levels.
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #5 ·
It'll still work anyway. You'll be getting your bass signal from one side, but there's no difference in left/right bass levels.
That sounds very good! Should I connect it to the front or rear speaker? Some say the rear speaker may get filtered. Is there any difference in the Ampera? :)
 
1 - 5 of 5 Posts
Top