GM Volt Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,509 Posts
Wow... through-hole soldering components. Haven't seen those in a while!

That looks like a typical molex connector issue. Sometimes caused by a bad crimp on the pin or socket, sometimes a bad alignment with the pin and socket, sometimes corrosion creates increased resistance at the connection point.

Looks like a day of labor to get to the board, 30 seconds with a solder iron, 30 seconds to put on some dielectric tune-up grease, and a day to get it back together.

Are there issues on the board other than pin R6?
 
1 - 1 of 1 Posts
Top