P0D3F P1EE6 and pending P1E00

5715 Views 17 Replies 7 Participants Last post by fishhawk, Dec 29, 2017

Alex Dee

Discussion Starter · Dec 10, 2017

Hi

So i just got an original (old) 240v voltec charger for my 2012 volt, and after about 60% of charging i threw the three codes P0D3F P1EE6 and pending P1E00. i looked them up, all seemed generic. so i wiped the codes and the plugged her back in, and had a green light. looked at the car 10 min later and the charging indicator light in the car is off, so i am assuming that the same codes came up.

I used to charge with the 120 charger all the time before it broke, and i charge at work with a charge-point charger every business day, so why the heck is the charger that was bought at the dealer givin me trouble? anyone else have this problem?

thank you

Save

1 - 1 of 18 Posts

fishhawk

· #18 · Dec 29, 2017 (Edited)

Hi Alex. I had one of the orange-corded 240 Voltec units that stopped working but would work again if I reset the breaker. I left the cover off and it stayed working, so similar experience to yours. I replaced the circuit board with an OpenEVSE board and it has been working for 5 years so far.

If you want to try this route, Steverino put together a tuturial that you can find here in the forums, or maybe he can link it for you.

EDIT: Found the link top Steverino's post:
http://gm-volt.com/forum/showthread.php?25513-Voltec-240v-Conversion-to-OpenEVSE

Save

1 - 1 of 18 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month