GM Volt Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Hi folks

I am attempting to reprogram the 14 volt inverter module in my 2011 volt(APM). I subscribed for SPS programming from Acdelco and am using an MDI interface. The programming always terminates with the error "m6413 off-board programming detected"

I notice this is the same error i get regardless of the module i select. Anyone encountered such a problem and how did you resolve it?

I am in Ghana and Chevrolet informs me there is no service outlet at my location. I have no choice than to take a DIY approach to all my volt-specific issues.



Anthony
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top