GM Volt Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
907 Posts
I would expect the Volt to monitor the cell leveling status during the "pause" in full charging. Could be a point where it decides to continue or throw a CEL. The end ramp is where the charger goes into constant (maximum) voltage charge. Another interesting point that I've measured is the ramp at the beginning. Volt doesn't go full on to 3.3KW (or even 1KW L1), but will slowly ramp up to full power over about 10-12 seconds. You can even see this on a Kill-a-Watt meter for L1.
 
1 - 1 of 1 Posts
Top