GM Volt Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
So I had to carry a door in my volt and I couldn't find a place to attach a bungee cord on to the hatch. So I just locked the latch with my fingers and put the bungee cord hook in the locking mechanism.

After I unloaded the door I couldn't unlatch the lock. I tried the fob and also the Unlock symbol on the center dash. I finally found a little plastic cover right above the latch so I pried it off. Inside you will see a square hole that you can insert a screwdriver into and it unlocked immediately.

Hope this helps someone.:)
 

· Registered
Joined
·
10,014 Posts
I did that and just pressed the button. 2013.

If I recall correctly, the hatch has to be down as far as it will go for this to work.
 

· Registered
Joined
·
125 Posts
The previous poster's reply should have solved your problem. Anything going through the hole where you put the bungee cord hook that you can apply pressure to in the direction away from the lock while pressing the unlock button will open and re-set the latch. Make sure you pull the latch far enough so that it locks in the "open" position. Pulling on the bungee cord hook should do the trick and then using the hook itself, press against the side of the latch until it locks open.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top