Worst case, some very fine grit sandpaper on the EVSE exterior may knock it down enough to ease the mating process. However, some Gen 1 owners experienced the same issue and it went away with use over time (6 months?).
EVSE Not Smooth
I use the included EVSE daily and it is difficult to insert and remove and isn’t getting any easier. Looking at it, I don’t see anything obvious that could be causing this. Removing it is usually harder than inserting it.
I’ve used several charging stations, as well as my father’s EVSE, which came with his 2013 Volt and they all go on much smoother and come off easier.
Anyone else that uses theirs regularly experiencing the same thing?
I’ve used several charging stations, as well as my father’s EVSE, which came with his 2013 Volt and they all go on much smoother and come off easier.
Anyone else that uses theirs regularly experiencing the same thing?
1 - 1 of 13 Posts
1 - 1 of 13 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
GM Volt Forum
A forum community dedicated to Chevy Volt electric car owners and enthusiasts. Come join the discussion about hybrid performance, modifications, classifieds, troubleshooting, maintenance, reviews, and more!
Full Forum Listing
Recommended Communities
