GM Volt Forum banner

EVSE Not Smooth

2064 Views 12 Replies 10 Participants Last post by  Dutch
I use the included EVSE daily and it is difficult to insert and remove and isn’t getting any easier. Looking at it, I don’t see anything obvious that could be causing this. Removing it is usually harder than inserting it.
I’ve used several charging stations, as well as my father’s EVSE, which came with his 2013 Volt and they all go on much smoother and come off easier.
Anyone else that uses theirs regularly experiencing the same thing?
1 - 2 of 13 Posts
Thanks for all the comments from the adults. I'll look more closely, take down any excess with some fine grit. If that doesn't work I'll lube it up. Does anyone see any issue with using spray silicone as described above?

Just kidding about the adults comment, I intentionally describe things with some innuendo.
1 - 2 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.