GM Volt Forum banner
1 - 1 of 1 Posts

19 Posts
Hi Somms,
Do you remember the steps you took to replace the port? I am about to go down this road with my 2011, 104,000 mile completely out of voltec warranty new to me car.

Main question is, did you disable all of the electrical systems first or was it basically:
1. jack up front end,
2. remove front driver wheel,
3. remove rear splash guard,
4. unplug the harnes,
5. remove the 4 bolts,
6. Installation is the reverse....

or do you have to remove the charging door assy and all that goes with it too?

trying to save a few bucks and DIY it. New receptacle is about $100 bucks on Amazon...
thanks in advance!
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.