GM Volt Forum banner

Clamp digging into Drive unit

1184 Views 6 Replies 6 Participants Last post by  Chevrolet Customer Svc
I figured a hose clamp is not positioned well and digging into the plastic cover of the drive unit. At 3k miles it made a deep enough ditch for me worry about the future. Maybe it is my bad luck but do check if yours is the same way. Below photos are after I turned it away.

Auto part Engine Vehicle Automotive engine part

Auto part

Bumper Auto part Rim Wheel
See less See more
1 - 1 of 7 Posts
I can't see the pictures yet, so this may be obvious once they are visible, but what is the fix? Just loosen a hose clamp, rotate it, and then tighten again?
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.