[twoheeldrive]

Fat32 is what you want. I used a 15GB USB 3.0 flash drive. The bin files are small, less than 30MB in total. There are four bin files.

The files I used are: 23108359.bin, 231083361.bin, 23210046.bin, 907993304.bin, and a file called indication.16005619

I can send them to you. PM me.

 

[Tjdupaix]

Si I've tried 3 different usb sticks format in fat32 and ntfs with no luck. I actually get a E4492 Cyber Security Access failure and E4423 Unknown reprogramming error 5 at step 0 error when attempting to program cluster with SPS2. I don't know if I can get a bin file from somewhere else to attempt the program as the cluster does recognize the usb when I plug one in but says no 22923964.bin found. I might have to call the acdelcotds helpdesk on Monday. I did turn off my antivirus and windows firewall with no luck. Thank you for the advise i've received so far.

I am running into this issue as well. Any update?

 

[Tjdupaix]

Si I've tried 3 different usb sticks format in fat32 and ntfs with no luck. I actually get a E4492 Cyber Security Access failure and E4423 Unknown reprogramming error 5 at step 0 error when attempting to program cluster with SPS2. I don't know if I can get a bin file from somewhere else to attempt the program as the cluster does recognize the usb when I plug one in but says no 22923964.bin found. I might have to call the acdelcotds helpdesk on Monday. I did turn off my antivirus and windows firewall with no luck. Thank you for the advise i've received so far.

I am running into this problem as well. Did you figure out the process?

 

[hvillegas1966]

Yes I did.
When you are in SPS and go into instrument (cluster) make sure you select the 1st step and insert a thumb drive onto laptop. I was caught up in a circle trying to perform step 2 as SPS thinks step 1 has been completed.
In the menu, highlight step 1 and this will download the correct bin file from AC delco, then continue with step 2 in inserting the thumb drive onto special cable in instrument cluster.
Good luck, but it should work.

 

[Ender]

Okay, here it comes
Why would i update the Instrument cluster and would it not have been updated on one of the service vists?
Volt from 12/2011 here

Ender

 

[Tjdupaix]

Okay, here it comes
Why would i update the Instrument cluster and would it not have been updated on one of the service vists?
Volt from 12/2011 here

Ender

You won’t ever need to. If you use vcx nano and reset everything it will be on the list of things you “can” reset.