GM Volt Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
I have schematics for getting the low level signals. They are front left and right, and rear left and right (just a copy of the front). If you've done an install before it shouldn't be a big deal. Mine was Bose, so I can't speak to what the non-Bose amp does, but the crossovers are in the Bose amp. If you don't have a sub (not sure what non-Bose has), there should be room under the floor for the amp (I took out the sub and mounted a signal processor there).
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top