GM Volt Forum banner
1 - 1 of 1 Posts

· Registered
6 Posts
Discussion Starter · #1 ·
Awhile back we had to replace the radio and used a salvage unit from a ice Spark. Radio works fine, but no ev-related programming is available.
We've been reprogramming our Volts using the SPS subscriptions (and VCX nano).
Trying to replace&reprogram the radio in the 2014 Spark ev, but it hangs up validating the controller.
An option we've never seen before is to transfer files by USB.
Anyone used this option?
Checking out other calibrations (Body Control Module, etc.)- show older versions (lower numbers) than the current ones. I haven't reprogrammed any module since the car works fine.
1 - 1 of 1 Posts