[marty2627]

Hi
I use the drive mode button to change from Hold to normal quite a lot, approaching 100,000 kms (Australia)
When I try to change the drive mode whilst driving , sometimes the button just will no change the drive mode, which is annoying, After 5 or 10 minutes of ouching the button sometimes it will. Sometimes it will change to "sport" mode, but not to hold.
Anyone ever had this problem? Need to go to dealer?

Thanks for reading!

 

[longflare]

Can't remember where I read it, (this forum somewhere), but some have had to replace the switch.
I think they are available at Holden.

 

[bentbiker]

Marty, see https://www.youtube.com/watch?v=QnjcsrcHkoM .

 

[marty2627]

Hiya bentbiker, thanks for your post!
Great video, I used a table knife instead of a small screwdriver, so less chance of scratching the surround while I leveraged the button till it popped - took a few minutes whilst I was careful , but then it "popped" and I removed the botton. Then flipped the button upside down, and used two tiny squares of adhesive electrical "cloth" type tape, to the "cross" which presses the internal white round button. I did stop and check that the white round button activates the change in drive mode, then as all was working, pushed the button back into its holder, and went for a drive... all is working ok.. can change modes just fine. Thanks to Edgar for the Video too!