GM Volt Forum banner

2012 Comfort setting, NO HEAT

3911 Views 29 Replies 11 Participants Last post by  emartin00
Well, it's been almost 6 years, and I've never had an issue with getting heat when I want it. I'm used to barely getting warm air in ECO, but today I had it in COMFORT and HI, and still the heat wouldn't come on.
So I did a remote start a couple minutes before leaving, but not long enough to really warm it up. When I got in, the air was slightly warm. Just after leaving my driveway, the thermometer dropped to 22F, so ERDTT kicked in. It heated up quick and provided nice warm air for about 5 minutes after the engine stopped. I kept it in COMFORT 76F for a while, and the air started getting cooler. I turned the temp up to no avail. I'm fighting a bit of an illness, so the cold was bothering me and I was getting frustrated. The engine never kicked back on either (and no HOLD).

Finally I stopped at a stoplight and shut the car down and restarted. When it came back on, the temp read 28F and the heat kicked on instantly. I had warm air in under a minute.

Electronics Multimedia Technology Electronic device Vehicle
See less See more
1 - 1 of 30 Posts
Some folks have had to reset the heating system (either a restart or fuse pull) to get heat back. Make sure your car has all the applicable software updates installed. Every car is unique. Only a qualified Volt tech can pull the required updates based on VIN. In the past, Volt advisers could do that, Their replacements: Chevy Electric Customer Support, may not have the same skills/capabilities.
1 - 1 of 30 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top