GM Volt Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. Newcomers, Owner Stories, FAQs
    Hi folks I am attempting to reprogram the 14 volt inverter module in my 2011 volt(APM). I subscribed for SPS programming from Acdelco and am using an MDI interface. The programming always terminates with the error "m6413 off-board programming detected" I notice this is the same error i get...
  2. Use, Care & Maintenance - Gen 1 Chevy Volt
    Hello Guys , I am new at this forum. I own 2011 chevy volt with 60K miles on it . I have had problems with Battery coolant level sensor with an error "service high voltage charging system" I changed sensor and every time I do it my volt needs a System Dump ( Reprogram) which is kind of a...
  3. Use, Care & Maintenance - Gen 1 Chevy Volt
    Greetings fellow Volt owners. I was a very early Volt adopter, purchased #639. I bought and programmed an extra key fob for it. The car was totaled a couple of months ago and I got a good deal on a 2013 as its replacement. I now want to use the extra 2011 key fob with the 2013. I've followed...
  4. Problems, Driver Warnings or DTCs - Gen 1 Volt
    I had an opportunity to program a new key fob to work with my 2011 Volt today. I followed the instructions on page 2-4/5. I got the message "READY FOR REMOTE #3" (two previously programmed). With the new fob in the "magic slot", I pressed the POWER button for two seconds, expecting the message...
  5. Use, Care & Maintenance - Gen 1 Chevy Volt
    With old and new fobs inside car Car off Fob batteries fresh Turned door lock key five times (heard clicks) Got "Ready for Remote 3" on dash Inserted fob's key in hole Pushed POWER for 2+ seconds Nothing... nothing... After 20 sec or so the "Ready" disappeared - blank display Tried this with...
  6. Generation 1 Chevy Volt (2011-2015)
    Okay, I thought I was going crazy yesterday. About 3 days ago, I programmed my universal remote into my Volt. I would drive up to my garage door, and it would not open until I pressed the button. Yesterday, I noticed that my garage door started opening when I pulled into my driveway. I...
  7. Software & Programming/Code - Chevy Volt
    The Volt uses an estimated 10 million lines of code, running about 100 control units. That's up from about six million lines of code in typical 2009 model cars and as little as 2.4 million in 2005. Each Volt has its own IP address. "They use it for a few things today, like finding a charging...
  8. Generation 1 Chevy Volt (2011-2015)
    I was just on the highway and I LOVE the way the Volt's cruise control works. Once you have it set a little window pops up on the display that tells you at what speed the cruise is set at....and the vehicle very accurately keeps the speed you have it set to. Once the cruise is set you can hit...
1-8 of 8 Results
Top